Protection for VHF / SSB / CB
Antenna Systems
 1.5 Mhz - 400 Mhz
- For general radio and
Transceiver use
- easy mountable- required no permanent mount
- Multi-strike Capability
- Low Strike Throughput Energy
Flange mounting coaxial protectors bolt to a flat surface and require no
permanent hole. Device is DC blocked to stop DC continuity and accommodate
all equipment types. Handles 50 kA max. surge current. Turn on voltage is
a nominal 600V. Device turns on 2.5ns after reaching DC threshold. Capable
of withstanding multiple strikes. Features aluminum enclosure and
stainless steel hardware.
Maximum Power Transmission:
| Frequency
Range (MHZ) |
Watts |
| 1.5 - 50 (SSB) |
2,000 |
| 50 - 220 (VHF) |
375 |
| 220-400 |
125 |
Protector Configuration:
Female UHF connector
on both sides of protector.
Suggested connection instuctions for VHF Transciever:
Connect VHF PL-259(UHF) male
connector (normally standard with most antennas) from antenna lead
in to antenna side of protector. Connect optional MMUHFR8X
cable from surge side to transciever antenna input. |
